
Operation&MaintenanceManualTX200-UNDP4075 East Market StreetYork, Pennsylvania, USA 17402Telephone: 717-840-0678 (Ext. 259)Fax: 717-755-8304Web-si
Page 9Procedure for Clearing TX200 between RefrigerantsThe TX200 can be used to recover many different refrigerants. If the recovered refrigerants are
Page 10COMPRESSOR MAINTENANCEBEFORE EACH USE...Check the TX200 Compressor oil level before each recovery procedure. The Oil Level Sight Glass is visib
Page 11CONDENSER MAINTENANCEClean the Condenser to maintain high efficiency performance of the TX200. Disconnect power and remove theCover. Blow compr
Page 12SPR ADJUSTMENTThe TX200 has been factory adjusted and tested for optimum performance at operating temperatures from 10to 490 C. Adjustment of t
Page 13PROBLEMS & SOLUTIONSOn rare occasion the TX200 may seem to be performing differently or not at all. Experience has shown thatvarying operat
Page 14ACCESSORY PARTS LIST
Page 16
Page 1!!!! TABLE OF CONTENTS !!!!TX200Before Using The TX200 Page 2Safety Precautions Page 3Recover Mode Page 4Oil Drain & Measure (Automotive
Page 2BEFORE USING THE TX200Check for any shipping damage. Place a claim with carrier if damage is discovered.DO NOT USE A DAMAGED UNIT.The TX200 shou
Page 3SAFETY PRECAUTIONS! Recover R12, R22, or R502 Refrigerant only.! Wear safety glasses and protective gloves. Refrigerant has a very low boiling p
Page 4RECOVERY MODEFigure 1 shows the recommended connection of the TX200 to an A/C System.CAUTION...The hose from the A/C System must be connected to
Page 5Connect TX200 Power Cord to a properly protected, grounded receptacle. Avoid using an extension cord. Ifnecessary, use a good condition, 3-wire
Page 6Allow this sequence to repeat until the Compressor-On Light remains off continuously for at least 2 minutes.The DEEP VACUUM Switch can be presse
Page 7Procedure for Fast RecoveryProcedure for Fast RecoveryProcedure for Fast RecoveryProcedure for Fast RecoveryThe goal of any technician is to rec
Page 8NON-CONDENSABLE PURGE CHART(BARS)0C R12 R22 R502 R134a0 3.03 5.45 6.34 2.901 3.15 5.63 6.59 3.012 3.28 5.79 6.76 3.103 3.38 6.00 6.97 3.284 3.52
Commenti su questo manuale